SEALEXCEL® Fine-Lok™/ Well-Lok™ Tube fittings have been carefully designed and manufactured with continuous research and development backing to very stringent tolerances under rigid Quality Control procedures approved to ISO 9001-2000 quality management systems to provide zero leak, Torque free seal in instrumentation and process tubing.
Tube fittings are available as standard stainless steel 316. The raw materials used confirm to chemical requirements listed in specification below...
Stainless steel 316 Tube fittings are heat code traceable back to the original mill heat from which it was made.
Tube fitting are rated for working pressure higher than the tubing recommended in tubing data table..
Stainless steel 304 and 316 fully annealed seamless tubing according to standard ASTM A213 or ASTM A269
Extra care must be taken while selecting tubing for gas application, In order to achieve a gas-tight seal, ferrules in instruments fittings must seal any minor surface imperfections.
PIPE END NPT AND ISO
Fitting that has both tube and pipe thread ends can have different pressure ratings. The pipe end pressure ratings chart ...
Tube Fittings consist of four precision component such as Nut, Back Ferrule, Front Ferrule and Body.
FINE-LOK TUBE FITTINGS
Tube Fittings consist of three precision component such as Nut, Single Ferrule and Body.
Ensure that, the end of the tube is cut square and free from burrs without causing undue chamfering of the tube end.
PIPE THREAD INFORMATION
Pipe fittings are available with NPT/BSP/ISO and SAE/MS straight thread.
The part Number describes completely assembled Fine-Lok / Well-Lok Tube fittings.
WELL-LOK TUBE FITTINGS
Precision Pipe Fittings
Ball Valves (High Pressure)
Three Way Ball Valves
Rising Stem Plug Valves
Integral Block Bleed Valves
Micron In-Line Filters
FEATURES & BENEFITS
Tube Fittings in SS316 are traceable
to certified material test report.
Extend the fittings life by preventing
galling across a wide range of
SILVER PLATED NUT
The leading edge of back ferrules
are case hardened.
Ensure strong Tube grip.
Precision Machined to very close
tolerances by monitoring critical
dimensions, surface finish, run out
and sharp edges.
SEALEXCEL® manufacture each
and everycomponents of Tube
Fittings to very close tolerances
Manufactured to maximum tolerances.
The Design of SEALEXCEL®
Well-Lok™ Twin Ferrule Tube Fittings
are similar to certain other
well-known Fittings manufacturers
37 Flare Tube FIttings
Tube FIttings as per DIN 2353
Quick Connect Couplings
SS Push in Fittings
SS Push on Fittings
Flow Control Regulators
Quick Exhaust Valves
Quick Connect Couplings
A slight taper in the base of the tube
socket in the Fitting body.